Building the Shack, Part 6

Framed the rafters and cut a ridge beam.

Still figuring out roofs. Went through a lot of revisions.

Used rise over run rather than angles as much as possible. Some bad math early on.

Pine a pleasure to cut on the tablesaw after all that rock-hard oak.

Rounded rafter ends a motif from early on in designs. Mirrored it with the ridge beam.

Might drill a hole and hang a lamp/planter/bird feeder off east and west ends of the beam.

Need to level the ground and lay a brick slab next. This is moving outside the workshop. Quixotic.

Leave a Reply

Your email address will not be published. Required fields are marked *